Tell us about the job
Takes about a minute. No obligation.
Sizing a heat pump for a house in McLennan County means working against a weather record that is genuinely demanding. 174 severe weather events were recorded in McLennan County, Texas between 2015 and 2024. At that rate, a system sized for a mild climate will run harder and recover longer than one sized for what this area actually delivers. A contractor quoting an install here factors that load into equipment selection from the start, because undersizing shows up in the first heavy season and compounds from there.
Ductwork laid down for a conventional system and then asked to carry a heat pump runs into a specific problem: heat pumps move larger volumes of air at lower temperature differentials, and ducts sized for something else can undercut efficiency before the new unit ever runs a full cycle. Half the homes in McLennan County, Texas were built in 1983 or earlier (2020-2024 ACS 5-year). That means a contractor doing a heat pump installation here spends real time on what the existing duct system actually delivers, checking static pressure and return capacity, before the equipment choice is settled. The electrical service gets the same look, since a heat pump's draw is a known quantity and the panel has to meet it. What the house already contains is what sets the scope.
What a Heat Pump Installation Covers
The outdoor unit sits on a pad beside the house and holds the compressor and coil that do the core work of moving heat. Inside, the air handler mounts in a utility space, closet, or attic and pushes conditioned air through the home. Together these two cabinets are what a new heat pump installation puts in place.
A refrigerant line set runs between the two units, connecting the outdoor pad to the air handler and carrying the working fluid that ties the system together. A thermostat goes on an interior wall and gives the homeowner control over the whole system. The disconnect box mounts near the outdoor unit and gives the contractor a safe shutoff point.
The drawing shows a representative layout, and a licensed contractor determines what the installation requires for this particular house.
Find a contractor in McLennan CountyMcLennan County, by the numbers
174 severe weather events were recorded in McLennan County, Texas between 2015 and 2024.
NOAA National Centers for Environmental Information, Storm Events Database, bulk CSV export, events 2015-01-01 through 2024-12-31.Half the homes in McLennan County, Texas were built in 1983 or earlier (2020-2024 ACS 5-year).
U.S. Census Bureau, 2020-2024 American Community Survey 5-Year EstimatesMcLennan County, Texas holds 108,454 housing units (2020-2024 ACS 5-year).
U.S. Census Bureau, 2020-2024 American Community Survey 5-Year EstimatesOwners occupy 61.8% of the occupied homes in McLennan County, Texas (2020-2024 ACS 5-year).
U.S. Census Bureau, 2020-2024 American Community Survey 5-Year EstimatesHeat Pump Installation Rules & Standards for McLennan County, Texas1 sourced codes and standards
Licensing and Legal Requirements in McLennan County, Texas
In Texas a person may not engage in air conditioning and refrigeration contracting unless that person holds a license issued under the state air conditioning and refrigeration contractor law.
Severe Weather Events in McLennan County
Weather in McLennan County puts real demands on heating and cooling equipment, and those demands shape what a heat pump here needs to handle year after year. Sizing and installing for local conditions is what separates a system that holds up from one that does not.
174 severe weather events, 2015–2024. Source: NOAA National Centers for Environmental Information, Storm Events Database.