Tell us about the job
Takes about a minute. No obligation.

A contractor sizing a heat pump for a Palo Pinto County home starts with the structure: square footage, insulation, window load, duct condition. 90 severe weather events were recorded in Palo Pinto County, Texas between 2015 and 2024. That record puts this county near the middle of the national range, which means severe weather is present but not the defining pressure on an installation. The equipment specs that matter here come from what the house holds and loses, not from bracing against an unusually punishing climate. A contractor who gets the load calculation right for this house is doing the job the local conditions actually call for.

Ductwork laid down for older heating and cooling equipment was designed around different airflow volumes than a heat pump moves. Half the homes in Palo Pinto County, Texas were built in 1979 or earlier (2020-2024 ACS 5-year). A contractor installing a heat pump in this county opens the job by tracing what is already in the walls and attic, checking whether the existing runs, plenums, and returns can carry the system without pressure problems. If they cannot, the duct work becomes part of the job before the unit is ever priced. The electrical service gets the same look, since older panels were not wired for the loads a heat pump draws.
What a Heat Pump Installation Covers

The outdoor unit sits on a pad beside the house and holds the compressor and coil that do the primary work of moving heat. Inside, an air handler mounts in a utility space, attic, or closet and circulates conditioned air through the home. These two units are what a new installation puts in place.
A refrigerant line set runs between the outdoor and indoor units, connecting the two halves of the system through the wall or roofline. A thermostat goes on an interior wall and gives the homeowner control over the whole system. Each piece has a fixed location that a contractor determines based on the layout of the house.
The drawing shows a typical heat pump layout, and a licensed contractor will determine exactly what applies to your home and how each piece is positioned.
Get matched in Palo Pinto CountyPalo Pinto County by the Numbers
90 severe weather events were recorded in Palo Pinto County, Texas between 2015 and 2024.
NOAA National Centers for Environmental Information, Storm Events Database, bulk CSV export, events 2015-01-01 through 2024-12-31.Half the homes in Palo Pinto County, Texas were built in 1979 or earlier (2020-2024 ACS 5-year).
U.S. Census Bureau, 2020-2024 American Community Survey 5-Year EstimatesPalo Pinto County, Texas holds 15,206 housing units (2020-2024 ACS 5-year).
U.S. Census Bureau, 2020-2024 American Community Survey 5-Year EstimatesOwners occupy 71.0% of the occupied homes in Palo Pinto County, Texas (2020-2024 ACS 5-year).
U.S. Census Bureau, 2020-2024 American Community Survey 5-Year EstimatesHeat Pump Installation Rules for Palo Pinto County, Texas1 codes, standards, and laws
Licensing and Legal Requirements in Palo Pinto County, Texas
In Texas a person may not engage in air conditioning and refrigeration contracting unless that person holds a license issued under the state air conditioning and refrigeration contractor law.
Severe Weather Events in Palo Pinto County
Extreme weather puts real hours on heating and cooling equipment, and Palo Pinto County has its own weather history. A heat pump sized and installed for local conditions holds up differently than one spec'd without that picture in mind.
90 severe weather events, 2015–2024. Source: NOAA National Centers for Environmental Information, Storm Events Database.