Tell us about the job
Takes about a minute. No obligation.
Before a contractor can quote a heat pump install in Floyd County, they have to settle what is actually driving the load: the structure, the duct layout, the existing equipment, and what the local climate asks of a system year-round. 93 severe weather events were recorded in Floyd County, Texas between 2015 and 2024. That puts this county close to the middle of the national distribution, where severe weather is real but not the dominant factor shaping an installation. A contractor sizing a heat pump here will spend more time on Manual J load calculations and duct condition than on compensating for extreme climate stress.
Ductwork laid down for an earlier era of equipment carries assumptions about airflow, return sizing, and routing that do not always match what a heat pump needs to move conditioned air efficiently through a house. Half the homes in Floyd County, Texas were built in 1962 or earlier (2020-2024 ACS 5-year). A contractor installing a heat pump here opens the duct system to check capacity and condition before the equipment selection is final, because the ducts determine whether the job is a straight swap or a more involved retrofit. Electrical service gets the same look, since the panel and the run to the unit have to carry the load the new equipment draws. The ductwork is where the scope gets set.
What a Heat Pump Installation Covers in Your Home
The outdoor unit sits on a pad beside the house and holds the compressor and coil that do the core work of moving heat in or out depending on the season. Inside, the air handler mounts in a utility space, closet, or attic and pushes conditioned air through the home. Together these two units are what a contractor puts in when the job is done.
A refrigerant line set runs between the outdoor unit and the air handler, carrying the fluid that links the two sides of the system. A thermostat goes on an interior wall where it reads the home's temperature and tells the system when to run. The disconnect box mounts near the outdoor unit and gives the contractor a safe shutoff point for the equipment.
The drawing shows a typical layout, and a licensed contractor determines what the installation looks like in your specific house.
Get matched in Floyd CountyFloyd County, by the numbers
93 severe weather events were recorded in Floyd County, Texas between 2015 and 2024.
NOAA National Centers for Environmental Information, Storm Events Database, bulk CSV export, events 2015-01-01 through 2024-12-31.Half the homes in Floyd County, Texas were built in 1962 or earlier (2020-2024 ACS 5-year).
U.S. Census Bureau, 2020-2024 American Community Survey 5-Year EstimatesFloyd County, Texas holds 2,592 housing units (2020-2024 ACS 5-year).
U.S. Census Bureau, 2020-2024 American Community Survey 5-Year EstimatesOwners occupy 73.3% of the occupied homes in Floyd County, Texas (2020-2024 ACS 5-year).
U.S. Census Bureau, 2020-2024 American Community Survey 5-Year EstimatesRules & Standards Governing Heat Pump Installation in Floyd County, Texas1 sourced rules and standards
Licensing Rules for HVAC Work in Floyd County, Texas
In Texas a person may not engage in air conditioning and refrigeration contracting unless that person holds a license issued under the state air conditioning and refrigeration contractor law.
Severe Weather Events in Floyd County
Weather puts a load on heating and cooling equipment, and that load is shaped by local conditions. A heat pump sized and installed for what Floyd County actually sees will perform differently than one built to a generic spec.
93 severe weather events, 2015–2024. Source: NOAA National Centers for Environmental Information, Storm Events Database.