Tell us about the job
Takes about a minute. No obligation.

A contractor quoting a heat pump install in Shelby County has to work out what the existing system has actually been through before settling on equipment specs. 84 severe weather events were recorded in Shelby County, Texas between 2015 and 2024. At that rate, severe weather is an occasional fact of life here, present but not the dominant force shaping every system in the county. What that means for installation is that sizing decisions rest more on the age and condition of the ductwork, the insulation quality of the house, and how well any previous system was commissioned than on preparing for a punishing storm cycle. A contractor who leans on local weather as the primary sizing variable would be reaching past the more likely explanation.

Ductwork sized and routed for a conventional system handles air differently than what a heat pump requires, and a house built generations ago was not designed with that difference in mind. Half the homes in Shelby County, Texas were built in 1984 or earlier (2020-2024 ACS 5-year). A contractor assessing a heat pump installation here opens the duct runs before pricing anything else, checking whether the existing passages will carry the airflow the new system demands. If they will not, the duct work becomes part of the job. The electrical service gets the same look, since the load a heat pump draws has to match what the panel can deliver.
What a Heat Pump Installation Puts in Your Home

The outdoor unit sits on a pad beside the house and holds the compressor and the coil that exchange heat with the outside air. Inside, the air handler mounts in a utility space, closet, or attic and moves conditioned air through the home. These two units are the core of what a contractor installs.
A refrigerant line set runs between the outdoor unit and the air handler, carrying refrigerant through insulated copper tubing. A condensate drain line runs from the air handler to a suitable drain point, and a thermostat mounts on an interior wall where it reads the home's temperature and signals the system.
The drawing shows a typical layout, and a licensed contractor determines exactly how each piece fits the specifics of your house.
Get matched in Shelby CountyShelby County, Texas, by the numbers
84 severe weather events were recorded in Shelby County, Texas between 2015 and 2024.
NOAA National Centers for Environmental Information, Storm Events Database, bulk CSV export, events 2015-01-01 through 2024-12-31.Half the homes in Shelby County, Texas were built in 1984 or earlier (2020-2024 ACS 5-year).
U.S. Census Bureau, 2020-2024 American Community Survey 5-Year EstimatesShelby County, Texas holds 11,584 housing units (2020-2024 ACS 5-year).
U.S. Census Bureau, 2020-2024 American Community Survey 5-Year EstimatesOwners occupy 74.0% of the occupied homes in Shelby County, Texas (2020-2024 ACS 5-year).
U.S. Census Bureau, 2020-2024 American Community Survey 5-Year EstimatesRules & Standards Behind Heat Pump Installation in Shelby County, Texas1 sourced rules and standards
Licensing and Legal Requirements in Shelby County, Texas
In Texas a person may not engage in air conditioning and refrigeration contracting unless that person holds a license issued under the state air conditioning and refrigeration contractor law.
Severe Weather Events in Shelby County
What the weather demands of heating and cooling equipment is not the same everywhere. A heat pump sized and installed for the load Shelby County puts on it will run differently than one built for somewhere else.
84 severe weather events, 2015–2024. Source: NOAA National Centers for Environmental Information, Storm Events Database.